Refresh Your Grout, Grout Coating, Bring Life Back to Your Grout
Technical Info and Installation Instructions – Rejuvicrete™
Grout Coating with Sealer Built In
Custom Blend of Urethane, Acrylic, and Silane
Completely change the look of your floors
Rejuvicrete™ is a product that will allow you to change the color of your existing grout. We have many exciting colors that aren’t available anywhere else. The coating makes a chemical bond to the surface of the grout, and leaves a matte finish that follows and duplicates the texture of your existing grout. Maintenance is very easy, just wipe down with a mild cleaner and you’re done. If you’re not ready to install new grout, and want a quick facelift that will last for years, then Rejuvicrete™ may be the best option for your project.
Surface preparation is key to successful application.
Fix the tiles and grout where possible. There might be areas with broken tiles or disintegrating grout. Clean up and replace what you can. Clean the grout surface using a grout cleaner to inhibit the growth of mold and mildew. Follow the directions that are provided with the grout cleaner. After cleaning the grout, protect the walking areas, and allow to dry for 24 hours before applying Rejuvicrete.
Apply Painters Tape to the Tile (optional)
Next, you need to mask off the tile surfaces if feasible for your project. If you will clean up as you go, you can skip this step. If not, use painters tape to cover the tile, allowing only the grout to show through. This is a tedious step, but will help with the cleanup..
Coating the Grout
Pour some of the Rejuvicrete in a disposable bowl. Begin applying the coating using an artist’s brush, or a painter’s trim brush that is as wide as the grout joint. You may want to take a paint brush and thin it with scizzors to make it easier to work with.
Work in small sections at a time with small amounts of the coating. Use smooth strokes to apply the coating, try to keep the coating only on the grout, but if you do get it on your tile, then it will come off. Let the first coat dry for 45 minutes, then lightly mist the area where you applied the coating. Using a firm plastic bristle brush, scrub the coating off of the tile surface and be extra careful not to remove any of the coating from the grout lines, after scrubbing the area, clean with a wet sponge. If you do remove the coating from the grout lines, then reapply. After you’re satisfied with the way it looks, allow the coating to cure for 24 hours before walking on, and 72 hours before using in a wet environment.